gpio/omap: fix build error when OF_GPIO is not defined.
The OMAP GPIO driver check if the chip has an associated
Device Tree node using the struct gpio_chip of_node member.
But this is only build if CONFIG_OF_GPIO is defined which
leads to the following error when using omap1_defconfig:
linux/drivers/gpio/gpio-omap.c: In function 'omap_gpio_chip_init':
linux/drivers/gpio/gpio-omap.c:1080:17: error: 'struct gpio_chip' has no member named 'of_node'
linux/drivers/gpio/gpio-omap.c: In function 'omap_gpio_irq_map':
linux/drivers/gpio/gpio-omap.c:1116:16: error: 'struct gpio_chip' has no member named 'of_node'
Reported-by: Kevin Hilman <khilman@linaro.org>
Signed-off-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 3a0c160..c57244e 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -1037,6 +1037,18 @@
IRQ_NOREQUEST | IRQ_NOPROBE, 0);
}
+#if defined(CONFIG_OF_GPIO)
+static inline bool omap_gpio_chip_boot_dt(struct gpio_chip *chip)
+{
+ return chip->of_node != NULL;
+}
+#else
+static inline bool omap_gpio_chip_boot_dt(struct gpio_chip *chip)
+{
+ return false;
+}
+#endif
+
static void omap_gpio_chip_init(struct gpio_bank *bank)
{
int j;
@@ -1077,7 +1089,7 @@
* irq_create_of_mapping() only for the GPIO lines that
* are used as interrupts.
*/
- if (!bank->chip.of_node)
+ if (!omap_gpio_chip_boot_dt(&bank->chip))
for (j = 0; j < bank->width; j++)
irq_create_mapping(bank->domain, j);
irq_set_chained_handler(bank->irq, gpio_irq_handler);
@@ -1113,7 +1125,7 @@
* but until then this has to be done on a per driver
* basis. Remove this once this is managed by the core.
*/
- if (bank->chip.of_node) {
+ if (omap_gpio_chip_boot_dt(&bank->chip)) {
gpio = irq_to_gpio(bank, hwirq);
ret = gpio_request_one(gpio, GPIOF_IN, NULL);
if (ret) {