s390: qeth driver fixes: VLAN hdr, perf stats
From: Ursula Braun <braunu@de.ibm.com>
- VLAN header reordering did not work on packets
received through qeth interface in layer 2 mode.
This caused dhcpcd not to work with VLAN devices.
- set qeth performance statistics initally inactive
Signed-off-by: Frank Pavlic <fpavlic@de.ibm.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/s390/net/qeth_main.c b/drivers/s390/net/qeth_main.c
index f17d7cf..015dc4c 100644
--- a/drivers/s390/net/qeth_main.c
+++ b/drivers/s390/net/qeth_main.c
@@ -1074,7 +1074,7 @@
card->options.layer2 = 1;
else
card->options.layer2 = 0;
- card->options.performance_stats = 1;
+ card->options.performance_stats = 0;
}
/**
@@ -2466,32 +2466,17 @@
qeth_rebuild_skb_fake_ll_eth(card, skb, hdr);
}
-static inline __u16
+static inline void
qeth_layer2_rebuild_skb(struct qeth_card *card, struct sk_buff *skb,
struct qeth_hdr *hdr)
{
- unsigned short vlan_id = 0;
-#ifdef CONFIG_QETH_VLAN
- struct vlan_hdr *vhdr;
-#endif
-
skb->pkt_type = PACKET_HOST;
skb->protocol = qeth_type_trans(skb, skb->dev);
if (card->options.checksum_type == NO_CHECKSUMMING)
skb->ip_summed = CHECKSUM_UNNECESSARY;
else
skb->ip_summed = CHECKSUM_NONE;
-#ifdef CONFIG_QETH_VLAN
- if (hdr->hdr.l2.flags[2] & (QETH_LAYER2_FLAG_VLAN)) {
- vhdr = (struct vlan_hdr *) skb->data;
- skb->protocol =
- __constant_htons(vhdr->h_vlan_encapsulated_proto);
- vlan_id = hdr->hdr.l2.vlan_id;
- skb_pull(skb, VLAN_HLEN);
- }
-#endif
*((__u32 *)skb->cb) = ++card->seqno.pkt_seqno;
- return vlan_id;
}
static inline __u16
@@ -2570,7 +2555,7 @@
&offset, &hdr))) {
skb->dev = card->dev;
if (hdr->hdr.l2.id == QETH_HEADER_TYPE_LAYER2)
- vlan_tag = qeth_layer2_rebuild_skb(card, skb, hdr);
+ qeth_layer2_rebuild_skb(card, skb, hdr);
else if (hdr->hdr.l3.id == QETH_HEADER_TYPE_LAYER3)
vlan_tag = qeth_rebuild_skb(card, skb, hdr);
else { /*in case of OSN*/