i2c: Bus drivers return -Errno not -1
Tighten error paths used by various i2c adapters (mostly x86) so
they return real fault/errno codes instead of a "-1" (which is
most often interpreted as "-EPERM"). Build tested, with eyeball
review.
One minor initial goal is to have adapters consistently return
the code "-ENXIO" when addressing a device doesn't get an ACK
response, at least in the probe paths where they are already
good at stifling related logspam.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Jean Delvare <khali@linux-fr.org>
diff --git a/drivers/i2c/busses/i2c-amd756.c b/drivers/i2c/busses/i2c-amd756.c
index 43508d6..3d5bcb6 100644
--- a/drivers/i2c/busses/i2c-amd756.c
+++ b/drivers/i2c/busses/i2c-amd756.c
@@ -151,17 +151,17 @@
}
if (temp & GS_PRERR_STS) {
- result = -1;
+ result = -ENXIO;
dev_dbg(&adap->dev, "SMBus Protocol error (no response)!\n");
}
if (temp & GS_COL_STS) {
- result = -1;
+ result = -EIO;
dev_warn(&adap->dev, "SMBus collision!\n");
}
if (temp & GS_TO_STS) {
- result = -1;
+ result = -ETIMEDOUT;
dev_dbg(&adap->dev, "SMBus protocol timeout!\n");
}
@@ -189,22 +189,23 @@
outw_p(inw(SMB_GLOBAL_ENABLE) | GE_ABORT, SMB_GLOBAL_ENABLE);
msleep(100);
outw_p(GS_CLEAR_STS, SMB_GLOBAL_STATUS);
- return -1;
+ return -EIO;
}
-/* Return -1 on error. */
+/* Return negative errno on error. */
static s32 amd756_access(struct i2c_adapter * adap, u16 addr,
unsigned short flags, char read_write,
u8 command, int size, union i2c_smbus_data * data)
{
int i, len;
+ int status;
/** TODO: Should I supporte the 10-bit transfers? */
switch (size) {
case I2C_SMBUS_PROC_CALL:
dev_dbg(&adap->dev, "I2C_SMBUS_PROC_CALL not supported!\n");
/* TODO: Well... It is supported, I'm just not sure what to do here... */
- return -1;
+ return -EOPNOTSUPP;
case I2C_SMBUS_QUICK:
outw_p(((addr & 0x7f) << 1) | (read_write & 0x01),
SMB_HOST_ADDRESS);
@@ -256,8 +257,9 @@
/* How about enabling interrupts... */
outw_p(size & GE_CYC_TYPE_MASK, SMB_GLOBAL_ENABLE);
- if (amd756_transaction(adap)) /* Error in transaction */
- return -1;
+ status = amd756_transaction(adap);
+ if (status)
+ return status;
if ((read_write == I2C_SMBUS_WRITE) || (size == AMD756_QUICK))
return 0;