ARM: set BE8 if LE in head code
If we are booting in LE and compiled for BE8, then add code to
set the state to bE8. Since the instruction stream is always LE,
we do not need to do anything special to the instruction.
Also ensure that the secondary processors are started in the same mode.
Note, we do add about 20 bytes to the kernel image, but it seems easier
to do this than adding another configuration to change.
Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk>
Reviewed-by: Dave Martin <Dave.Martin@arm.com>
Tested-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
diff --git a/arch/arm/kernel/head.S b/arch/arm/kernel/head.S
index 9e5906c..a047acf 100644
--- a/arch/arm/kernel/head.S
+++ b/arch/arm/kernel/head.S
@@ -77,6 +77,7 @@
__HEAD
ENTRY(stext)
+ ARM_BE8(setend be ) @ ensure we are in BE8 mode
THUMB( adr r9, BSYM(1f) ) @ Kernel is always entered in ARM.
THUMB( bx r9 ) @ If this is a Thumb-2 kernel,
@@ -352,6 +353,9 @@
* the processor type - there is no need to check the machine type
* as it has already been validated by the primary processor.
*/
+
+ ARM_BE8(setend be) @ ensure we are in BE8 mode
+
#ifdef CONFIG_ARM_VIRT_EXT
bl __hyp_stub_install_secondary
#endif