pinconf-generic: add BIAS_BUS_HOLD pinconf
Add a new PIN_CONFIG_BIAS_BUS_HOLD pin configuration for a bus holder
pin mode (also known as bus keeper, or repeater). This is a weak latch
which drives the last value on a tristate bus. Another device on the bus
can drive the bus high or low before going tristate to change the value
driven by the pin.
Signed-off-by: James Hogan <james.hogan@imgtec.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/pinconf-generic.c b/drivers/pinctrl/pinconf-generic.c
index 33a5392..ba465b3 100644
--- a/drivers/pinctrl/pinconf-generic.c
+++ b/drivers/pinctrl/pinconf-generic.c
@@ -37,6 +37,7 @@
static struct pin_config_item conf_items[] = {
PCONFDUMP(PIN_CONFIG_BIAS_DISABLE, "input bias disabled", NULL),
PCONFDUMP(PIN_CONFIG_BIAS_HIGH_IMPEDANCE, "input bias high impedance", NULL),
+ PCONFDUMP(PIN_CONFIG_BIAS_BUS_HOLD, "input bias bus hold", NULL),
PCONFDUMP(PIN_CONFIG_BIAS_PULL_UP, "input bias pull up", NULL),
PCONFDUMP(PIN_CONFIG_BIAS_PULL_DOWN, "input bias pull down", NULL),
PCONFDUMP(PIN_CONFIG_DRIVE_PUSH_PULL, "output drive push pull", NULL),