[media] usb/gspca/cpia1.c: use IS_ENABLED() macro
replace:
#if defined(CONFIG_INPUT) || \
defined(CONFIG_INPUT_MODULE)
with:
#if IS_ENABLED(CONFIG_INPUT)
This change was made for: CONFIG_INPUT
Reported-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Peter Senna Tschudin <peter.senna@gmail.com>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/usb/gspca/cpia1.c b/drivers/media/usb/gspca/cpia1.c
index b3ba47d..1dcdd9f 100644
--- a/drivers/media/usb/gspca/cpia1.c
+++ b/drivers/media/usb/gspca/cpia1.c
@@ -541,7 +541,7 @@
/* test button press */
a = ((gspca_dev->usb_buf[1] & 0x02) == 0);
if (a != sd->params.qx3.button) {
-#if defined(CONFIG_INPUT) || defined(CONFIG_INPUT_MODULE)
+#if IS_ENABLED(CONFIG_INPUT)
input_report_key(gspca_dev->input_dev, KEY_CAMERA, a);
input_sync(gspca_dev->input_dev);
#endif
@@ -1640,7 +1640,7 @@
/* Update the camera status */
do_command(gspca_dev, CPIA_COMMAND_GetCameraStatus, 0, 0, 0, 0);
-#if defined(CONFIG_INPUT) || defined(CONFIG_INPUT_MODULE)
+#if IS_ENABLED(CONFIG_INPUT)
/* If the last button state is pressed, release it now! */
if (sd->params.qx3.button) {
/* The camera latch will hold the pressed state until we reset
@@ -1869,7 +1869,7 @@
.stopN = sd_stopN,
.dq_callback = sd_dq_callback,
.pkt_scan = sd_pkt_scan,
-#if defined(CONFIG_INPUT) || defined(CONFIG_INPUT_MODULE)
+#if IS_ENABLED(CONFIG_INPUT)
.other_input = 1,
#endif
};