drm/i915: add DP test request handling
DPCD 1.1+ adds some automated test infrastructure support. Add support
for reading the IRQ source and jumping to a test handling routine if
needed. Subsequent patches will handle particular tests; this patch
just ACKs any requested tests by default.
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Signed-off-by: Keith Packard <keithp@keithp.com>
diff --git a/include/drm/drm_dp_helper.h b/include/drm/drm_dp_helper.h
index 2b1a358..0d2f727 100644
--- a/include/drm/drm_dp_helper.h
+++ b/include/drm/drm_dp_helper.h
@@ -153,6 +153,12 @@
# define DP_PSR_CRC_VERIFICATION (1 << 2)
# define DP_PSR_FRAME_CAPTURE (1 << 3)
+#define DP_DEVICE_SERVICE_IRQ_VECTOR 0x201
+# define DP_REMOTE_CONTROL_COMMAND_PENDING (1 << 0)
+# define DP_AUTOMATED_TEST_REQUEST (1 << 1)
+# define DP_CP_IRQ (1 << 2)
+# define DP_SINK_SPECIFIC_IRQ (1 << 6)
+
#define DP_LANE0_1_STATUS 0x202
#define DP_LANE2_3_STATUS 0x203
# define DP_LANE_CR_DONE (1 << 0)
@@ -185,6 +191,25 @@
# define DP_ADJUST_PRE_EMPHASIS_LANE1_MASK 0xc0
# define DP_ADJUST_PRE_EMPHASIS_LANE1_SHIFT 6
+#define DP_TEST_REQUEST 0x218
+# define DP_TEST_LINK_TRAINING (1 << 0)
+# define DP_TEST_LINK_PATTERN (1 << 1)
+# define DP_TEST_LINK_EDID_READ (1 << 2)
+# define DP_TEST_LINK_PHY_TEST_PATTERN (1 << 3) /* DPCD >= 1.1 */
+
+#define DP_TEST_LINK_RATE 0x219
+# define DP_LINK_RATE_162 (0x6)
+# define DP_LINK_RATE_27 (0xa)
+
+#define DP_TEST_LANE_COUNT 0x220
+
+#define DP_TEST_PATTERN 0x221
+
+#define DP_TEST_RESPONSE 0x260
+# define DP_TEST_ACK (1 << 0)
+# define DP_TEST_NAK (1 << 1)
+# define DP_TEST_EDID_CHECKSUM_WRITE (1 << 2)
+
#define DP_SET_POWER 0x600
# define DP_SET_POWER_D0 0x1
# define DP_SET_POWER_D3 0x2