Merge branch 'master' into sh/smp
Conflicts:
arch/sh/mm/cache-sh4.c
diff --git a/arch/sh/mm/Kconfig b/arch/sh/mm/Kconfig
index 2795618..64dc1ad 100644
--- a/arch/sh/mm/Kconfig
+++ b/arch/sh/mm/Kconfig
@@ -82,7 +82,7 @@
config PMB_ENABLE
bool "Support 32-bit physical addressing through PMB"
- depends on MMU && EXPERIMENTAL && (CPU_SUBTYPE_SH7780 || CPU_SUBTYPE_SH7785)
+ depends on MMU && EXPERIMENTAL && (CPU_SUBTYPE_SH7757 || CPU_SUBTYPE_SH7780 || CPU_SUBTYPE_SH7785)
select 32BIT
default y
help
@@ -97,7 +97,7 @@
config PMB
bool "PMB"
- depends on MMU && EXPERIMENTAL && (CPU_SUBTYPE_SH7780 || CPU_SUBTYPE_SH7785)
+ depends on MMU && EXPERIMENTAL && (CPU_SUBTYPE_SH7757 || CPU_SUBTYPE_SH7780 || CPU_SUBTYPE_SH7785)
select 32BIT
help
If you say Y here, physical addressing will be extended to
@@ -106,7 +106,8 @@
config PMB_FIXED
bool "fixed PMB"
- depends on MMU && EXPERIMENTAL && (CPU_SUBTYPE_SH7780 || \
+ depends on MMU && EXPERIMENTAL && (CPU_SUBTYPE_SH7757 || \
+ CPU_SUBTYPE_SH7780 || \
CPU_SUBTYPE_SH7785)
select 32BIT
help
diff --git a/arch/sh/mm/cache-sh4.c b/arch/sh/mm/cache-sh4.c
index 2775f84..70fb906 100644
--- a/arch/sh/mm/cache-sh4.c
+++ b/arch/sh/mm/cache-sh4.c
@@ -455,7 +455,49 @@
* Break the 1, 2 and 4 way variants of this out into separate functions to
* avoid nearly all the overhead of having the conditional stuff in the function
* bodies (+ the 1 and 2 way cases avoid saving any registers too).
+ *
+ * We want to eliminate unnecessary bus transactions, so this code uses
+ * a non-obvious technique.
+ *
+ * Loop over a cache way sized block of, one cache line at a time. For each
+ * line, use movca.a to cause the current cache line contents to be written
+ * back, but without reading anything from main memory. However this has the
+ * side effect that the cache is now caching that memory location. So follow
+ * this with a cache invalidate to mark the cache line invalid. And do all
+ * this with interrupts disabled, to avoid the cache line being accidently
+ * evicted while it is holding garbage.
+ *
+ * This also breaks in a number of circumstances:
+ * - if there are modifications to the region of memory just above
+ * empty_zero_page (for example because a breakpoint has been placed
+ * there), then these can be lost.
+ *
+ * This is because the the memory address which the cache temporarily
+ * caches in the above description is empty_zero_page. So the
+ * movca.l hits the cache (it is assumed that it misses, or at least
+ * isn't dirty), modifies the line and then invalidates it, losing the
+ * required change.
+ *
+ * - If caches are disabled or configured in write-through mode, then
+ * the movca.l writes garbage directly into memory.
*/
+static void __flush_dcache_segment_writethrough(unsigned long start,
+ unsigned long extent_per_way)
+{
+ unsigned long addr;
+ int i;
+
+ addr = CACHE_OC_ADDRESS_ARRAY | (start & cpu_data->dcache.entry_mask);
+
+ while (extent_per_way) {
+ for (i = 0; i < cpu_data->dcache.ways; i++)
+ __raw_writel(0, addr + cpu_data->dcache.way_incr * i);
+
+ addr += cpu_data->dcache.linesz;
+ extent_per_way -= cpu_data->dcache.linesz;
+ }
+}
+
static void __flush_dcache_segment_1way(unsigned long start,
unsigned long extent_per_way)
{
@@ -655,24 +697,30 @@
*/
void __init sh4_cache_init(void)
{
+ unsigned int wt_enabled = !!(__raw_readl(CCR) & CCR_CACHE_WT);
+
printk("PVR=%08x CVR=%08x PRR=%08x\n",
ctrl_inl(CCN_PVR),
ctrl_inl(CCN_CVR),
ctrl_inl(CCN_PRR));
- switch (boot_cpu_data.dcache.ways) {
- case 1:
- __flush_dcache_segment_fn = __flush_dcache_segment_1way;
- break;
- case 2:
- __flush_dcache_segment_fn = __flush_dcache_segment_2way;
- break;
- case 4:
- __flush_dcache_segment_fn = __flush_dcache_segment_4way;
- break;
- default:
- panic("unknown number of cache ways\n");
- break;
+ if (wt_enabled)
+ __flush_dcache_segment_fn = __flush_dcache_segment_writethrough;
+ else {
+ switch (boot_cpu_data.dcache.ways) {
+ case 1:
+ __flush_dcache_segment_fn = __flush_dcache_segment_1way;
+ break;
+ case 2:
+ __flush_dcache_segment_fn = __flush_dcache_segment_2way;
+ break;
+ case 4:
+ __flush_dcache_segment_fn = __flush_dcache_segment_4way;
+ break;
+ default:
+ panic("unknown number of cache ways\n");
+ break;
+ }
}
local_flush_icache_range = sh4_flush_icache_range;
diff --git a/arch/sh/mm/ioremap_32.c b/arch/sh/mm/ioremap_32.c
index da2f418..c325061 100644
--- a/arch/sh/mm/ioremap_32.c
+++ b/arch/sh/mm/ioremap_32.c
@@ -57,14 +57,6 @@
if (is_pci_memory_fixed_range(phys_addr, size))
return (void __iomem *)phys_addr;
-#if !defined(CONFIG_PMB_FIXED)
- /*
- * Don't allow anybody to remap normal RAM that we're using..
- */
- if (phys_addr < virt_to_phys(high_memory))
- return NULL;
-#endif
-
/*
* Mappings have to be page-aligned
*/
diff --git a/arch/sh/mm/tlb-sh4.c b/arch/sh/mm/tlb-sh4.c
index 7d3c63e..8cf550e 100644
--- a/arch/sh/mm/tlb-sh4.c
+++ b/arch/sh/mm/tlb-sh4.c
@@ -43,9 +43,12 @@
*/
ctrl_outl(pte.pte_high, MMU_PTEA);
#else
- if (cpu_data->flags & CPU_HAS_PTEA)
- /* TODO: make this look less hacky */
- ctrl_outl(((pteval >> 28) & 0xe) | (pteval & 0x1), MMU_PTEA);
+ if (cpu_data->flags & CPU_HAS_PTEA) {
+ /* The last 3 bits and the first one of pteval contains
+ * the PTEA timing control and space attribute bits
+ */
+ ctrl_outl(copy_ptea_attributes(pteval), MMU_PTEA);
+ }
#endif
/* Set PTEL register */