Remove multiple KERN_ prefixes from printk formats
Commit 5fd29d6ccbc98884569d6f3105aeca70858b3e0f ("printk: clean up
handling of log-levels and newlines") changed printk semantics. printk
lines with multiple KERN_<level> prefixes are no longer emitted as
before the patch.
<level> is now included in the output on each additional use.
Remove all uses of multiple KERN_<level>s in formats.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/net/dl2k.c b/drivers/net/dl2k.c
index 895d721..4b6a219 100644
--- a/drivers/net/dl2k.c
+++ b/drivers/net/dl2k.c
@@ -268,8 +268,9 @@
printk(KERN_INFO "tx_coalesce:\t%d packets\n",
tx_coalesce);
if (np->coalesce)
- printk(KERN_INFO "rx_coalesce:\t%d packets\n"
- KERN_INFO "rx_timeout: \t%d ns\n",
+ printk(KERN_INFO
+ "rx_coalesce:\t%d packets\n"
+ "rx_timeout: \t%d ns\n",
np->rx_coalesce, np->rx_timeout*640);
if (np->vlan)
printk(KERN_INFO "vlan(id):\t%d\n", np->vlan);
@@ -1522,9 +1523,9 @@
printk (KERN_INFO "Operating at 10 Mbps, ");
}
if (bmcr & MII_BMCR_DUPLEX_MODE) {
- printk ("Full duplex\n");
+ printk (KERN_CONT "Full duplex\n");
} else {
- printk ("Half duplex\n");
+ printk (KERN_CONT "Half duplex\n");
}
}
if (np->tx_flow)
@@ -1614,9 +1615,9 @@
}
if (np->full_duplex) {
bmcr |= MII_BMCR_DUPLEX_MODE;
- printk ("Full duplex\n");
+ printk (KERN_CONT "Full duplex\n");
} else {
- printk ("Half duplex\n");
+ printk (KERN_CONT "Half duplex\n");
}
#if 0
/* Set 1000BaseT Master/Slave setting */
@@ -1669,9 +1670,9 @@
__u16 bmcr = mii_read (dev, phy_addr, PCS_BMCR);
printk (KERN_INFO "Operating at 1000 Mbps, ");
if (bmcr & MII_BMCR_DUPLEX_MODE) {
- printk ("Full duplex\n");
+ printk (KERN_CONT "Full duplex\n");
} else {
- printk ("Half duplex\n");
+ printk (KERN_CONT "Half duplex\n");
}
}
if (np->tx_flow)