OMAP3: Move common regulator configuration to twl-common
Some regulator config can be moved out from board files,
since they are close to identical.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-igep0020.c b/arch/arm/mach-omap2/board-igep0020.c
index e0a6687..35be778 100644
--- a/arch/arm/mach-omap2/board-igep0020.c
+++ b/arch/arm/mach-omap2/board-igep0020.c
@@ -479,26 +479,6 @@
.default_device = &igep2_dvi_device,
};
-static struct regulator_consumer_supply igep2_vpll2_supplies[] = {
- REGULATOR_SUPPLY("vdds_dsi", "omapdss"),
- REGULATOR_SUPPLY("vdds_dsi", "omapdss_dsi1"),
-};
-
-static struct regulator_init_data igep2_vpll2 = {
- .constraints = {
- .name = "VDVI",
- .min_uV = 1800000,
- .max_uV = 1800000,
- .apply_uV = true,
- .valid_modes_mask = REGULATOR_MODE_NORMAL
- | REGULATOR_MODE_STANDBY,
- .valid_ops_mask = REGULATOR_CHANGE_MODE
- | REGULATOR_CHANGE_STATUS,
- },
- .num_consumer_supplies = ARRAY_SIZE(igep2_vpll2_supplies),
- .consumer_supplies = igep2_vpll2_supplies,
-};
-
static void __init igep2_display_init(void)
{
int err = gpio_request_one(IGEP2_GPIO_DVI_PUP, GPIOF_OUT_INIT_HIGH,
@@ -579,9 +559,11 @@
pr_warning("IGEP2: Could not register I2C3 bus (%d)\n", ret);
igep_twldata.keypad = &igep2_keypad_pdata;
- igep_twldata.vpll2 = &igep2_vpll2;
- /* Use common codec data */
- omap3_pmic_get_config(&igep_twldata, TWL_COMMON_PDATA_AUDIO, 0);
+ /* Get common pmic data */
+ omap3_pmic_get_config(&igep_twldata, TWL_COMMON_PDATA_AUDIO,
+ TWL_COMMON_REGULATOR_VPLL2);
+ igep_twldata.vpll2->constraints.apply_uV = true;
+ igep_twldata.vpll2->constraints.name = "VDVI";
}
omap3_pmic_init("twl4030", &igep_twldata);