mtd: add read_byte support to plat_nand
Lantiq SoCs have a External Bus Unit (EBU) that is used to attach MTD media.
As we need to co-exist with PCI on the same bus, certain swapping settings must
be applied. Similar to the NOR map driver we need to apply a fix to make NAND
work. The easiest way is to use byte reads.
Signed-off-by: John Crispin <blogic@openwrt.org>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/plat_nand.c b/drivers/mtd/nand/plat_nand.c
index fd2d2a1..1bcb520 100644
--- a/drivers/mtd/nand/plat_nand.c
+++ b/drivers/mtd/nand/plat_nand.c
@@ -79,6 +79,7 @@
data->chip.select_chip = pdata->ctrl.select_chip;
data->chip.write_buf = pdata->ctrl.write_buf;
data->chip.read_buf = pdata->ctrl.read_buf;
+ data->chip.read_byte = pdata->ctrl.read_byte;
data->chip.chip_delay = pdata->chip.chip_delay;
data->chip.options |= pdata->chip.options;
data->chip.bbt_options |= pdata->chip.bbt_options;
diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h
index 627f0c5..94a6679 100644
--- a/include/linux/mtd/nand.h
+++ b/include/linux/mtd/nand.h
@@ -654,6 +654,7 @@
void (*cmd_ctrl)(struct mtd_info *mtd, int dat, unsigned int ctrl);
void (*write_buf)(struct mtd_info *mtd, const uint8_t *buf, int len);
void (*read_buf)(struct mtd_info *mtd, uint8_t *buf, int len);
+ unsigned char (*read_byte)(struct mtd_info *mtd);
void *priv;
};