[POWERPC] PPC 4xx: Enable XMON on PPC 4xx boards
The following patch allows XMON to run on the 4xx platform. Tested on
Walnut, Ebony, and Nova (440GX based) eval boards. 440EP, 440SP, and
440SPE boards should work as well. Patch is against 2.6.18-rc6.
Signed-off-by: Josh Boyer <jdub@us.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/ppc/xmon/start.c b/arch/ppc/xmon/start.c
index f7e9298..d74a883 100644
--- a/arch/ppc/xmon/start.c
+++ b/arch/ppc/xmon/start.c
@@ -15,6 +15,7 @@
#include <asm/processor.h>
#include <asm/delay.h>
#include <asm/btext.h>
+#include <asm/ibm4xx.h>
static volatile unsigned char *sccc, *sccd;
unsigned int TXRDY, RXRDY, DLAB;
@@ -57,23 +58,30 @@
void
xmon_map_scc(void)
{
-#ifdef CONFIG_PPC_PREP
- volatile unsigned char *base;
-
-#elif defined(CONFIG_GEMINI)
+#if defined(CONFIG_GEMINI)
/* should already be mapped by the kernel boot */
- sccc = (volatile unsigned char *) 0xffeffb0d;
sccd = (volatile unsigned char *) 0xffeffb08;
- TXRDY = 0x20;
- RXRDY = 1;
- DLAB = 0x80;
#elif defined(CONFIG_405GP)
- sccc = (volatile unsigned char *)0xef600305;
sccd = (volatile unsigned char *)0xef600300;
+#elif defined(CONFIG_440EP)
+ sccd = (volatile unsigned char *) ioremap(PPC440EP_UART0_ADDR, 8);
+#elif defined(CONFIG_440SP)
+ sccd = (volatile unsigned char *) ioremap64(PPC440SP_UART0_ADDR, 8);
+#elif defined(CONFIG_440SPE)
+ sccd = (volatile unsigned char *) ioremap64(PPC440SPE_UART0_ADDR, 8);
+#elif defined(CONFIG_44x)
+ /* This is the default for 44x platforms. Any boards that have a
+ different UART address need to be put in cases before this or the
+ port will be mapped incorrectly */
+ sccd = (volatile unsigned char *) ioremap64(PPC440GP_UART0_ADDR, 8);
+#endif /* platform */
+
+#ifndef CONFIG_PPC_PREP
+ sccc = sccd + 5;
TXRDY = 0x20;
RXRDY = 1;
DLAB = 0x80;
-#endif /* platform */
+#endif
register_sysrq_key('x', &sysrq_xmon_op);
}