omap: Fix gpio_request calls to happen as arch_initcall
Looks like some boards are calling gpio_request from init_irq.
This will make the request_irq fail, as GPIO will be initialized
as postcore_initcall.
Reported-by: Paul Walmsley <paul@pwsan.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap1/board-h3.c b/arch/arm/mach-omap1/board-h3.c
index 9126e3e..7871919 100644
--- a/arch/arm/mach-omap1/board-h3.c
+++ b/arch/arm/mach-omap1/board-h3.c
@@ -264,6 +264,15 @@
.resource = smc91x_resources,
};
+static void __init h3_init_smc91x(void)
+{
+ omap_cfg_reg(W15_1710_GPIO40);
+ if (gpio_request(40, "SMC91x irq") < 0) {
+ printk("Error requesting gpio 40 for smc91x irq\n");
+ return;
+ }
+}
+
#define GPTIMER_BASE 0xFFFB1400
#define GPTIMER_REGS(x) (0xFFFB1400 + (x * 0x800))
#define GPTIMER_REGS_SIZE 0x46
@@ -376,6 +385,8 @@
static void __init h3_init(void)
{
+ h3_init_smc91x();
+
/* Here we assume the NOR boot config: NOR on CS3 (possibly swapped
* to address 0 by a dip switch), NAND on CS2B. The NAND driver will
* notice whether a NAND chip is enabled at probe time.
@@ -422,21 +433,11 @@
h3_mmc_init();
}
-static void __init h3_init_smc91x(void)
-{
- omap_cfg_reg(W15_1710_GPIO40);
- if (gpio_request(40, "SMC91x irq") < 0) {
- printk("Error requesting gpio 40 for smc91x irq\n");
- return;
- }
-}
-
static void __init h3_init_irq(void)
{
omap1_init_common_hw();
omap_init_irq();
omap_gpio_init();
- h3_init_smc91x();
}
static void __init h3_map_io(void)