ARM: OMAP2+: Add structure for storing GPMC settings
The GPMC has various different configuration options such as bus-width,
synchronous or asychronous mode selection, burst mode options etc.
Currently, there is no central structure for storing all these options
when configuring the GPMC for a given device. Some of the options are
stored in the GPMC timing structure and some are directly programmed
into the GPMC configuration register. Add a new structure to store
these options and convert code to use this structure. Adding this
structure will allow us to create a common function for configuring
these options.
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
Tested-by: Ezequiel Garcia <ezequiel.garcia@free-electrons.com>
diff --git a/arch/arm/mach-omap2/gpmc.h b/arch/arm/mach-omap2/gpmc.h
index 697ff42..39e4e04 100644
--- a/arch/arm/mach-omap2/gpmc.h
+++ b/arch/arm/mach-omap2/gpmc.h
@@ -60,8 +60,8 @@
#define GPMC_CONFIG1_DEVICETYPE_NOR GPMC_CONFIG1_DEVICETYPE(0)
#define GPMC_CONFIG1_MUXTYPE(val) ((val & 3) << 8)
#define GPMC_CONFIG1_MUXNONMUX GPMC_CONFIG1_MUXTYPE(0)
-#define GPMC_CONFIG1_MUXAAD GPMC_CONFIG1_MUXTYPE(1)
-#define GPMC_CONFIG1_MUXADDDATA GPMC_CONFIG1_MUXTYPE(2)
+#define GPMC_CONFIG1_MUXAAD GPMC_CONFIG1_MUXTYPE(GPMC_MUX_AAD)
+#define GPMC_CONFIG1_MUXADDDATA GPMC_CONFIG1_MUXTYPE(GPMC_MUX_AD)
#define GPMC_CONFIG1_TIME_PARA_GRAN (1 << 4)
#define GPMC_CONFIG1_FCLK_DIV(val) (val & 3)
#define GPMC_CONFIG1_FCLK_DIV2 (GPMC_CONFIG1_FCLK_DIV(1))
@@ -76,6 +76,8 @@
#define GPMC_IRQ_FIFOEVENTENABLE 0x01
#define GPMC_IRQ_COUNT_EVENT 0x02
+#define GPMC_MUX_AAD 1 /* Addr-Addr-Data multiplex */
+#define GPMC_MUX_AD 2 /* Addr-Data multiplex */
/* bool type time settings */
struct gpmc_bool_timings {
@@ -181,10 +183,6 @@
u8 cyc_wpl; /* write deassertion time in cycles */
u32 cyc_iaa; /* initial access time in cycles */
- bool mux; /* address & data muxed */
- bool sync_write;/* synchronous write */
- bool sync_read; /* synchronous read */
-
/* extra delays */
bool ce_xdelay;
bool avd_xdelay;
@@ -192,8 +190,24 @@
bool we_xdelay;
};
+struct gpmc_settings {
+ bool burst_wrap; /* enables wrap bursting */
+ bool burst_read; /* enables read page/burst mode */
+ bool burst_write; /* enables write page/burst mode */
+ bool device_nand; /* device is NAND */
+ bool sync_read; /* enables synchronous reads */
+ bool sync_write; /* enables synchronous writes */
+ bool wait_on_read; /* monitor wait on reads */
+ bool wait_on_write; /* monitor wait on writes */
+ u32 burst_len; /* page/burst length */
+ u32 device_width; /* device bus width (8 or 16 bit) */
+ u32 mux_add_data; /* multiplex address & data */
+ u32 wait_pin; /* wait-pin to be used */
+};
+
extern int gpmc_calc_timings(struct gpmc_timings *gpmc_t,
- struct gpmc_device_timings *dev_t);
+ struct gpmc_settings *gpmc_s,
+ struct gpmc_device_timings *dev_t);
extern void gpmc_update_nand_reg(struct gpmc_nand_regs *reg, int cs);
extern int gpmc_get_client_irq(unsigned irq_config);