OMAPDSS: DPI: Maintain our own timings field in driver data
The DPI driver currently relies on the timings in omap_dss_device struct to
configure the DISPC accordingly. This makes the DPI interface driver dependent
on the omap_dss_device struct.
Make the DPI driver data maintain it's own timings field. The panel driver is
expected to call dpi_set_timings()(renamed to omapdss_dpi_set_timings) to set
these timings before the panel is enabled.
In the set_timings() op, we still ensure that the omap_dss_device timings
(dssdev->panel.timings) are configured. This will later be configured only by
the DPI panel drivers.
Signed-off-by: Archit Taneja <archit@ti.com>
diff --git a/drivers/video/omap2/displays/panel-picodlp.c b/drivers/video/omap2/displays/panel-picodlp.c
index 2d35bd3..0d7a8ff 100644
--- a/drivers/video/omap2/displays/panel-picodlp.c
+++ b/drivers/video/omap2/displays/panel-picodlp.c
@@ -377,6 +377,9 @@
* then only i2c commands can be successfully sent to dpp2600
*/
msleep(1000);
+
+ omapdss_dpi_set_timings(dssdev, &dssdev->panel.timings);
+
r = omapdss_dpi_display_enable(dssdev);
if (r) {
dev_err(&dssdev->dev, "failed to enable DPI\n");