x86: convert Dprintk to pr_debug
There are a couple of places where (P)Dprintk is used which is an old
compile time enabled printk wrapper. Convert it to the generic
pr_debug().
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
diff --git a/arch/x86/kernel/acpi/boot.c b/arch/x86/kernel/acpi/boot.c
index f489d7a..fa88a1d 100644
--- a/arch/x86/kernel/acpi/boot.c
+++ b/arch/x86/kernel/acpi/boot.c
@@ -1021,7 +1021,7 @@
mp_bus_id_to_type[MP_ISA_BUS] = MP_BUS_ISA;
#endif
set_bit(MP_ISA_BUS, mp_bus_not_pci);
- Dprintk("Bus #%d is ISA\n", MP_ISA_BUS);
+ pr_debug("Bus #%d is ISA\n", MP_ISA_BUS);
#ifdef CONFIG_X86_ES7000
/*
@@ -1127,8 +1127,8 @@
return gsi;
}
if (test_bit(ioapic_pin, mp_ioapic_routing[ioapic].pin_programmed)) {
- Dprintk(KERN_DEBUG "Pin %d-%d already programmed\n",
- mp_ioapic_routing[ioapic].apic_id, ioapic_pin);
+ pr_debug(KERN_DEBUG "Pin %d-%d already programmed\n",
+ mp_ioapic_routing[ioapic].apic_id, ioapic_pin);
#ifdef CONFIG_X86_32
return (gsi < IRQ_COMPRESSION_START ? gsi : gsi_to_irq[gsi]);
#else