net: fec: restart the FEC when PHY speed changes
Proviously we would only restart the FEC when PHY link or duplex state
changed. PHY does not always bring down the link for speed changes, in
which case we would not detect any change and keep FEC running.
Switching link speed without restarting the FEC results in the FEC being
stuck in an indefinite state, generating error conditions for every
packet.
Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/freescale/fec.c b/drivers/net/ethernet/freescale/fec.c
index 069a155..61d2e62 100644
--- a/drivers/net/ethernet/freescale/fec.c
+++ b/drivers/net/ethernet/freescale/fec.c
@@ -934,24 +934,28 @@
goto spin_unlock;
}
- /* Duplex link change */
if (phy_dev->link) {
- if (fep->full_duplex != phy_dev->duplex) {
- fec_restart(ndev, phy_dev->duplex);
- /* prevent unnecessary second fec_restart() below */
+ if (!fep->link) {
fep->link = phy_dev->link;
status_change = 1;
}
- }
- /* Link on or off change */
- if (phy_dev->link != fep->link) {
- fep->link = phy_dev->link;
- if (phy_dev->link)
+ if (fep->full_duplex != phy_dev->duplex)
+ status_change = 1;
+
+ if (phy_dev->speed != fep->speed) {
+ fep->speed = phy_dev->speed;
+ status_change = 1;
+ }
+
+ /* if any of the above changed restart the FEC */
+ if (status_change)
fec_restart(ndev, phy_dev->duplex);
- else
+ } else {
+ if (fep->link) {
fec_stop(ndev);
- status_change = 1;
+ status_change = 1;
+ }
}
spin_unlock:
diff --git a/drivers/net/ethernet/freescale/fec.h b/drivers/net/ethernet/freescale/fec.h
index f539007..eb43729 100644
--- a/drivers/net/ethernet/freescale/fec.h
+++ b/drivers/net/ethernet/freescale/fec.h
@@ -240,6 +240,7 @@
phy_interface_t phy_interface;
int link;
int full_duplex;
+ int speed;
struct completion mdio_done;
int irq[FEC_IRQ_NUM];
int bufdesc_ex;