mtd: gpmi: add a new field for HW_GPMI_TIMING1
The gpmi_nfc_compute_hardware_timing{} should contains all the
fields setting for gpmi timing registers. It already contains the fields
for HW_GPMI_TIMING0 and HW_GPMI_CTRL1.
So it is better to add a new field setting for HW_GPMI_TIMING1 in
this data structure. This makes the code more clear in logic.
This patch also changes some comments to make the code more readable.
Signed-off-by: Huang Shijie <b32955@freescale.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
index 2289cf8..c95dbe8 100644
--- a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
+++ b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
@@ -728,6 +728,7 @@
hw->address_setup_in_cycles = address_setup_in_cycles;
hw->use_half_periods = dll_use_half_periods;
hw->sample_delay_factor = sample_delay_factor;
+ hw->device_busy_timeout = GPMI_DEFAULT_BUSY_TIMEOUT;
/* Return success. */
return 0;
@@ -752,26 +753,26 @@
goto err_out;
}
- /* set ready/busy timeout */
- writel(0x500 << BP_GPMI_TIMING1_BUSY_TIMEOUT,
- gpmi_regs + HW_GPMI_TIMING1);
-
/* Get the timing information we need. */
nfc->clock_frequency_in_hz = clk_get_rate(r->clock[0]);
clock_period_in_ns = 1000000000 / nfc->clock_frequency_in_hz;
gpmi_nfc_compute_hardware_timing(this, &hw);
- /* Set up all the simple timing parameters. */
+ /* [1] Set HW_GPMI_TIMING0 */
reg = BF_GPMI_TIMING0_ADDRESS_SETUP(hw.address_setup_in_cycles) |
BF_GPMI_TIMING0_DATA_HOLD(hw.data_hold_in_cycles) |
BF_GPMI_TIMING0_DATA_SETUP(hw.data_setup_in_cycles) ;
writel(reg, gpmi_regs + HW_GPMI_TIMING0);
- /*
- * DLL_ENABLE must be set to 0 when setting RDN_DELAY or HALF_PERIOD.
- */
+ /* [2] Set HW_GPMI_TIMING1 */
+ writel(BF_GPMI_TIMING1_BUSY_TIMEOUT(hw.device_busy_timeout),
+ gpmi_regs + HW_GPMI_TIMING1);
+
+ /* [3] The following code is to set the HW_GPMI_CTRL1. */
+
+ /* DLL_ENABLE must be set to 0 when setting RDN_DELAY or HALF_PERIOD. */
writel(BM_GPMI_CTRL1_DLL_ENABLE, gpmi_regs + HW_GPMI_CTRL1_CLR);
/* Clear out the DLL control fields. */