[PATCH] libata: implement ata_dev_enabled and disabled()
This patch renames ata_dev_present() to ata_dev_enabled() and adds
ata_dev_disabled(). This is to discern the state where a device is
present but disabled from not-present state. This disctinction is
necessary when configuring transfer mode because device selection
timing must not be violated even if a device fails to configure.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/scsi/libata-scsi.c b/drivers/scsi/libata-scsi.c
index 53f5b0d..c1a4b29 100644
--- a/drivers/scsi/libata-scsi.c
+++ b/drivers/scsi/libata-scsi.c
@@ -2349,7 +2349,7 @@
(scsidev->lun != 0)))
return NULL;
- if (unlikely(!ata_dev_present(dev)))
+ if (unlikely(!ata_dev_enabled(dev)))
return NULL;
if (!atapi_enabled || (ap->flags & ATA_FLAG_NO_ATAPI)) {
@@ -2743,7 +2743,7 @@
for (i = 0; i < ATA_MAX_DEVICES; i++) {
dev = &ap->device[i];
- if (ata_dev_present(dev))
+ if (ata_dev_enabled(dev))
scsi_scan_target(&ap->host->shost_gendev, 0, i, 0, 0);
}
}