[PATCH] pcmcia: use bitfield instead of p_state and state
Instead of the two status values struct pcmcia_device->p_state and state,
use descriptive bitfields. Most value-checking in drivers was invalid, as
the core now only calls the ->remove() (a.k.a. detach) function in case the
attachement _and_ configuration was successful.
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/wireless/wavelan_cs.c b/drivers/net/wireless/wavelan_cs.c
index 6b67696..f7724eb 100644
--- a/drivers/net/wireless/wavelan_cs.c
+++ b/drivers/net/wireless/wavelan_cs.c
@@ -3983,12 +3983,9 @@
if(i != CS_SUCCESS)
{
cs_error(link, ParseTuple, i);
- link->state &= ~DEV_CONFIG_PENDING;
return FALSE;
}
-
- /* Configure card */
- link->state |= DEV_CONFIG;
+
do
{
i = pcmcia_request_io(link, &link->io);
@@ -4071,7 +4068,6 @@
}
while(0); /* Humm... Disguised goto !!! */
- link->state &= ~DEV_CONFIG_PENDING;
/* If any step failed, release any partially configured state */
if(i != 0)
{
@@ -4651,7 +4647,6 @@
/* Other specific data */
dev->mtu = WAVELAN_MTU;
- p_dev->state |= DEV_PRESENT | DEV_CONFIG_PENDING;
ret = wv_pcmcia_config(p_dev);
if (ret)
return ret;
@@ -4686,17 +4681,8 @@
printk(KERN_DEBUG "-> wavelan_detach(0x%p)\n", link);
#endif
- /*
- * If the device is currently configured and active, we won't
- * actually delete it yet. Instead, it is marked so that when the
- * release() function is called, that will trigger a proper
- * detach().
- */
- if(link->state & DEV_CONFIG)
- {
- /* Some others haven't done their job : give them another chance */
- wv_pcmcia_release(link);
- }
+ /* Some others haven't done their job : give them another chance */
+ wv_pcmcia_release(link);
/* Free pieces */
if(link->priv)
@@ -4731,7 +4717,7 @@
/* Stop receiving new messages and wait end of transmission */
wv_ru_stop(dev);
- if ((link->state & DEV_CONFIG) && (link->open))
+ if (link->open)
netif_device_detach(dev);
/* Power down the module */
@@ -4744,7 +4730,7 @@
{
struct net_device * dev = (struct net_device *) link->priv;
- if ((link->state & DEV_CONFIG) && (link->open)) {
+ if (link->open) {
wv_hw_reset(dev);
netif_device_attach(dev);
}