[MTD] devices: Clean up trailing white spaces
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
diff --git a/drivers/mtd/devices/doc2000.c b/drivers/mtd/devices/doc2000.c
index 5fc5328..be5e88b 100644
--- a/drivers/mtd/devices/doc2000.c
+++ b/drivers/mtd/devices/doc2000.c
@@ -4,7 +4,7 @@
* (c) 1999 Machine Vision Holdings, Inc.
* (c) 1999, 2000 David Woodhouse <dwmw2@infradead.org>
*
- * $Id: doc2000.c,v 1.66 2005/01/05 18:05:12 dwmw2 Exp $
+ * $Id: doc2000.c,v 1.67 2005/11/07 11:14:24 gleixner Exp $
*/
#include <linux/kernel.h>
@@ -58,7 +58,7 @@
size_t *retlen, u_char *buf, u_char *eccbuf, struct nand_oobinfo *oobsel);
static int doc_write_ecc(struct mtd_info *mtd, loff_t to, size_t len,
size_t *retlen, const u_char *buf, u_char *eccbuf, struct nand_oobinfo *oobsel);
-static int doc_writev_ecc(struct mtd_info *mtd, const struct kvec *vecs,
+static int doc_writev_ecc(struct mtd_info *mtd, const struct kvec *vecs,
unsigned long count, loff_t to, size_t *retlen,
u_char *eccbuf, struct nand_oobinfo *oobsel);
static int doc_read_oob(struct mtd_info *mtd, loff_t ofs, size_t len,
@@ -76,14 +76,14 @@
{
volatile char dummy;
int i;
-
+
for (i = 0; i < cycles; i++) {
if (DoC_is_Millennium(doc))
dummy = ReadDOC(doc->virtadr, NOP);
else
dummy = ReadDOC(doc->virtadr, DOCStatus);
}
-
+
}
/* DOC_WaitReady: Wait for RDY line to be asserted by the flash chip */
@@ -220,8 +220,8 @@
WriteDOC(ofs & 0xff, docptr, WritePipeTerm);
DoC_Delay(doc, 2); /* Needed for some slow flash chips. mf. */
-
- /* FIXME: The SlowIO's for millennium could be replaced by
+
+ /* FIXME: The SlowIO's for millennium could be replaced by
a single WritePipeTerm here. mf. */
/* Lower the ALE line */
@@ -377,9 +377,9 @@
if (mfr == 0xff || mfr == 0)
return 0;
- /* Check it's the same as the first chip we identified.
+ /* Check it's the same as the first chip we identified.
* M-Systems say that any given DiskOnChip device should only
- * contain _one_ type of flash part, although that's not a
+ * contain _one_ type of flash part, although that's not a
* hardware restriction. */
if (doc->mfr) {
if (doc->mfr == mfr && doc->id == id)
@@ -397,7 +397,7 @@
for (j = 0; nand_manuf_ids[j].id != 0x0; j++) {
if (nand_manuf_ids[j].id == mfr)
break;
- }
+ }
printk(KERN_INFO
"Flash chip found: Manufacturer ID: %2.2X, "
"Chip ID: %2.2X (%s:%s)\n", mfr, id,
@@ -405,7 +405,7 @@
if (!doc->mfr) {
doc->mfr = mfr;
doc->id = id;
- doc->chipshift =
+ doc->chipshift =
ffs((nand_flash_ids[i].chipsize << 20)) - 1;
doc->page256 = (nand_flash_ids[i].pagesize == 256) ? 1 : 0;
doc->pageadrlen = doc->chipshift > 25 ? 3 : 2;
@@ -467,7 +467,7 @@
ret = 0;
- /* Fill out the chip array with {floor, chipno} for each
+ /* Fill out the chip array with {floor, chipno} for each
* detected chip in the device. */
for (floor = 0; floor < MAX_FLOORS; floor++) {
for (chip = 0; chip < numchips[floor]; chip++) {
@@ -757,12 +757,12 @@
(long)from, eccbuf[0], eccbuf[1], eccbuf[2],
eccbuf[3], eccbuf[4], eccbuf[5]);
#endif
-
+
/* disable the ECC engine */
WriteDOC(DOC_ECC_DIS, docptr , ECCConf);
}
- /* according to 11.4.1, we need to wait for the busy line
+ /* according to 11.4.1, we need to wait for the busy line
* drop if we read to the end of the page. */
if(0 == ((from + len) & 0x1ff))
{
@@ -941,7 +941,7 @@
/* Let the caller know we completed it */
*retlen += len;
-
+
if (eccbuf) {
unsigned char x[8];
size_t dummy;
@@ -950,10 +950,10 @@
/* Write the ECC data to flash */
for (di=0; di<6; di++)
x[di] = eccbuf[di];
-
+
x[6]=0x55;
x[7]=0x55;
-
+
ret = doc_write_oob_nolock(mtd, to, 8, &dummy, x);
if (ret) {
up(&this->lock);
@@ -970,7 +970,7 @@
return 0;
}
-static int doc_writev_ecc(struct mtd_info *mtd, const struct kvec *vecs,
+static int doc_writev_ecc(struct mtd_info *mtd, const struct kvec *vecs,
unsigned long count, loff_t to, size_t *retlen,
u_char *eccbuf, struct nand_oobinfo *oobsel)
{
@@ -1022,7 +1022,7 @@
break;
to += thislen;
- }
+ }
up(&writev_buf_sem);
*retlen = totretlen;
@@ -1080,7 +1080,7 @@
/* Reading the full OOB data drops us off of the end of the page,
* causing the flash device to go into busy mode, so we need
* to wait until ready 11.4.1 and Toshiba TC58256FT docs */
-
+
ret = DoC_WaitReady(this);
up(&this->lock);
@@ -1190,7 +1190,7 @@
return 0;
}
-
+
static int doc_write_oob(struct mtd_info *mtd, loff_t ofs, size_t len,
size_t * retlen, const u_char * buf)
{
@@ -1222,7 +1222,7 @@
}
instr->state = MTD_ERASING;
-
+
/* FIXME: Do this in the background. Use timers or schedule_task() */
while(len) {
mychip = &this->chips[ofs >> this->chipshift];