iwlwifi: use scan while idle
As idle is just a deep powersave mode for
the device, it will easily scan while idle
since that turns off powersave.
This reduces the number of commands sent
to the device when scanning.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-scan.c b/drivers/net/wireless/iwlwifi/iwl-scan.c
index 863ad0c..4338d49 100644
--- a/drivers/net/wireless/iwlwifi/iwl-scan.c
+++ b/drivers/net/wireless/iwlwifi/iwl-scan.c
@@ -806,8 +806,12 @@
rate_flags |= iwl_ant_idx_to_flags(priv->scan_tx_ant[band]);
scan->tx_cmd.rate_n_flags = iwl_hw_set_rate_n_flags(rate, rate_flags);
- /* In power save mode use one chain, otherwise use all chains */
- if (test_bit(STATUS_POWER_PMI, &priv->shrd->status)) {
+ /*
+ * In power save mode while associated use one chain,
+ * otherwise use all chains
+ */
+ if (test_bit(STATUS_POWER_PMI, &priv->shrd->status) &&
+ !(priv->hw->conf.flags & IEEE80211_CONF_IDLE)) {
/* rx_ant has been set to all valid chains previously */
active_chains = rx_ant &
((u8)(priv->chain_noise_data.active_chains));