net: calxedaxgmac: Wake-on-LAN fixes
WOL is broken because the magic packet status bit is getting set rather
than the enable bit. The PMT interrupt is not getting serviced because
the PMT interrupt is also enabled on the global interrupt, but not
cleared by the global interrupt and the global interrupt is higher
priority. This fixes both of these issues to get WOL working.
There's still a problem with receive after resume, but at least now we
can wake-up.
Signed-off-by: Rob Herring <rob.herring@calxeda.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/calxeda/xgmac.c b/drivers/net/ethernet/calxeda/xgmac.c
index bb1e80b..b0ebc9f 100644
--- a/drivers/net/ethernet/calxeda/xgmac.c
+++ b/drivers/net/ethernet/calxeda/xgmac.c
@@ -163,6 +163,7 @@
#define XGMAC_FLOW_CTRL_FCB_BPA 0x00000001 /* Flow Control Busy ... */
/* XGMAC_INT_STAT reg */
+#define XGMAC_INT_STAT_PMTIM 0x00800000 /* PMT Interrupt Mask */
#define XGMAC_INT_STAT_PMT 0x0080 /* PMT Interrupt Status */
#define XGMAC_INT_STAT_LPI 0x0040 /* LPI Interrupt Status */
@@ -960,6 +961,9 @@
writel(DMA_INTR_DEFAULT_MASK, ioaddr + XGMAC_DMA_STATUS);
writel(DMA_INTR_DEFAULT_MASK, ioaddr + XGMAC_DMA_INTR_ENA);
+ /* Mask power mgt interrupt */
+ writel(XGMAC_INT_STAT_PMTIM, ioaddr + XGMAC_INT_STAT);
+
/* XGMAC requires AXI bus init. This is a 'magic number' for now */
writel(0x0077000E, ioaddr + XGMAC_DMA_AXI_BUS);
@@ -1828,7 +1832,7 @@
unsigned int pmt = 0;
if (mode & WAKE_MAGIC)
- pmt |= XGMAC_PMT_POWERDOWN | XGMAC_PMT_MAGIC_PKT;
+ pmt |= XGMAC_PMT_POWERDOWN | XGMAC_PMT_MAGIC_PKT_EN;
if (mode & WAKE_UCAST)
pmt |= XGMAC_PMT_POWERDOWN | XGMAC_PMT_GLBL_UNICAST;