OMAP: board-files: remove custom PD GPIO handling for DVI output
Now that the panel-dvi driver handles the PD (power-down) GPIO, we can
remove the custom PD handling from the board files.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Acked-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c
index 7be8d65..59f281f 100644
--- a/arch/arm/mach-omap2/board-omap3beagle.c
+++ b/arch/arm/mach-omap2/board-omap3beagle.c
@@ -189,24 +189,9 @@
/* DSS */
-static int beagle_enable_dvi(struct omap_dss_device *dssdev)
-{
- if (gpio_is_valid(dssdev->reset_gpio))
- gpio_set_value(dssdev->reset_gpio, 1);
-
- return 0;
-}
-
-static void beagle_disable_dvi(struct omap_dss_device *dssdev)
-{
- if (gpio_is_valid(dssdev->reset_gpio))
- gpio_set_value(dssdev->reset_gpio, 0);
-}
-
static struct panel_dvi_platform_data dvi_panel = {
- .platform_enable = beagle_enable_dvi,
- .platform_disable = beagle_disable_dvi,
.i2c_bus_num = 3,
+ .power_down_gpio = -1,
};
static struct omap_dss_device beagle_dvi_device = {
@@ -215,7 +200,6 @@
.driver_name = "dvi",
.data = &dvi_panel,
.phy.dpi.data_lines = 24,
- .reset_gpio = -EINVAL,
};
static struct omap_dss_device beagle_tv_device = {
@@ -236,16 +220,6 @@
.default_device = &beagle_dvi_device,
};
-static void __init beagle_display_init(void)
-{
- int r;
-
- r = gpio_request_one(beagle_dvi_device.reset_gpio, GPIOF_OUT_INIT_LOW,
- "DVI reset");
- if (r < 0)
- printk(KERN_ERR "Unable to get DVI reset GPIO\n");
-}
-
#include "sdram-micron-mt46h32m32lf-6.h"
static struct omap2_hsmmc_info mmc[] = {
@@ -309,7 +283,7 @@
if (gpio_request_one(gpio + 1, GPIOF_IN, "EHCI_nOC"))
pr_err("%s: unable to configure EHCI_nOC\n", __func__);
}
- beagle_dvi_device.reset_gpio = beagle_config.reset_gpio;
+ dvi_panel.power_down_gpio = beagle_config.reset_gpio;
gpio_request_one(gpio + TWL4030_GPIO_MAX, beagle_config.usb_pwr_level,
"nEN_USB_PWR");
@@ -552,7 +526,6 @@
omap_mux_init_signal("sdrc_cke0", OMAP_PIN_OUTPUT);
omap_mux_init_signal("sdrc_cke1", OMAP_PIN_OUTPUT);
- beagle_display_init();
beagle_opp_init();
}