arm: at91: dt: at91sam9 add serial pinctrl support
Set the dbgu pinctrl config by default as we have only one possible config
For other uart set the rxd/txd by default.
For at91sam9x5ek create soc based dts as we need to include specific soc dtsi.
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/arch/arm/boot/dts/at91sam9g25ek.dts b/arch/arm/boot/dts/at91sam9g25ek.dts
index 877c08f..c5ab16f 100644
--- a/arch/arm/boot/dts/at91sam9g25ek.dts
+++ b/arch/arm/boot/dts/at91sam9g25ek.dts
@@ -7,55 +7,10 @@
* Licensed under GPLv2 or later.
*/
/dts-v1/;
-/include/ "at91sam9x5.dtsi"
-/include/ "at91sam9x5cm.dtsi"
+/include/ "at91sam9g25.dtsi"
+/include/ "at91sam9x5ek.dtsi"
/ {
model = "Atmel AT91SAM9G25-EK";
compatible = "atmel,at91sam9g25ek", "atmel,at91sam9x5ek", "atmel,at91sam9x5", "atmel,at91sam9";
-
- chosen {
- bootargs = "console=ttyS0,115200 root=/dev/mtdblock1 rw rootfstype=ubifs ubi.mtd=1 root=ubi0:rootfs";
- };
-
- ahb {
- apb {
- dbgu: serial@fffff200 {
- status = "okay";
- };
-
- usart0: serial@f801c000 {
- status = "okay";
- };
-
- macb0: ethernet@f802c000 {
- phy-mode = "rmii";
- status = "okay";
- };
-
- i2c0: i2c@f8010000 {
- status = "okay";
- };
-
- i2c1: i2c@f8014000 {
- status = "okay";
- };
-
- i2c2: i2c@f8018000 {
- status = "okay";
- };
- };
-
- usb0: ohci@00600000 {
- status = "okay";
- num-ports = <2>;
- atmel,vbus-gpio = <&pioD 19 1
- &pioD 20 1
- >;
- };
-
- usb1: ehci@00700000 {
- status = "okay";
- };
- };
};