PCI: use dev_printk in quirk messages
Convert quirk printks to dev_printk().
I made the MSI disable messages a little more consistent:
- always use "disabled", not "deactivated"
- specify "device MSI disabled" or "subordinate MSI disabled" when
disabling MSI for only a specific device or subordinate bus
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c
index c225159..0ee694f 100644
--- a/drivers/usb/host/pci-quirks.c
+++ b/drivers/usb/host/pci-quirks.c
@@ -190,9 +190,8 @@
msleep(10);
}
if (wait_time <= 0)
- printk(KERN_WARNING "%s %s: BIOS handoff "
- "failed (BIOS bug ?) %08x\n",
- pdev->dev.bus_id, "OHCI",
+ dev_warn(&pdev->dev, "OHCI: BIOS handoff failed"
+ " (BIOS bug?) %08x\n",
readl(base + OHCI_CONTROL));
/* reset controller, preserving RWC */
@@ -243,8 +242,7 @@
switch (cap & 0xff) {
case 1: /* BIOS/SMM/... handoff support */
if ((cap & EHCI_USBLEGSUP_BIOS)) {
- pr_debug("%s %s: BIOS handoff\n",
- pdev->dev.bus_id, "EHCI");
+ dev_dbg(&pdev->dev, "EHCI: BIOS handoff\n");
#if 0
/* aleksey_gorelov@phoenix.com reports that some systems need SMI forced on,
@@ -285,9 +283,8 @@
/* well, possibly buggy BIOS... try to shut
* it down, and hope nothing goes too wrong
*/
- printk(KERN_WARNING "%s %s: BIOS handoff "
- "failed (BIOS bug ?) %08x\n",
- pdev->dev.bus_id, "EHCI", cap);
+ dev_warn(&pdev->dev, "EHCI: BIOS handoff failed"
+ " (BIOS bug?) %08x\n", cap);
pci_write_config_byte(pdev, offset + 2, 0);
}
@@ -306,17 +303,14 @@
cap = 0;
/* FALLTHROUGH */
default:
- printk(KERN_WARNING "%s %s: unrecognized "
- "capability %02x\n",
- pdev->dev.bus_id, "EHCI",
- cap & 0xff);
+ dev_warn(&pdev->dev, "EHCI: unrecognized capability "
+ "%02x\n", cap & 0xff);
break;
}
offset = (cap >> 8) & 0xff;
}
if (!count)
- printk(KERN_DEBUG "%s %s: capability loop?\n",
- pdev->dev.bus_id, "EHCI");
+ dev_printk(KERN_DEBUG, &pdev->dev, "EHCI: capability loop?\n");
/*
* halt EHCI & disable its interrupts in any case