UBI: amend comments after all the renamings
This patch amends commentaries in scan.[ch] to match the new logic. Reminder -
we did the restructuring to prepare the code for adding the fastmap. This patch
also renames a couple of functions - it was too difficult to separate out that
change and I decided that it is not too bad to have it in the same patch with
commentaries changes.
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
diff --git a/drivers/mtd/ubi/build.c b/drivers/mtd/ubi/build.c
index 2a8f26b..7f293b2 100644
--- a/drivers/mtd/ubi/build.c
+++ b/drivers/mtd/ubi/build.c
@@ -27,10 +27,6 @@
* module load parameters or the kernel boot parameters. If MTD devices were
* specified, UBI does not attach any MTD device, but it is possible to do
* later using the "UBI control device".
- *
- * At the moment we only attach UBI devices by scanning, which will become a
- * bottleneck when flashes reach certain large size. Then one may improve UBI
- * and add other methods, although it does not seem to be easy to do.
*/
#include <linux/err.h>
@@ -790,11 +786,11 @@
ubi_msg("data offset: %d", ubi->leb_start);
/*
- * Note, ideally, we have to initialize ubi->bad_peb_count here. But
+ * Note, ideally, we have to initialize @ubi->bad_peb_count here. But
* unfortunately, MTD does not provide this information. We should loop
* over all physical eraseblocks and invoke mtd->block_is_bad() for
- * each physical eraseblock. So, we skip ubi->bad_peb_count
- * uninitialized and initialize it after scanning.
+ * each physical eraseblock. So, we leave @ubi->bad_peb_count
+ * uninitialized so far.
*/
return 0;
@@ -805,7 +801,7 @@
* @ubi: UBI device description object
* @vol_id: ID of the volume to re-size
*
- * This function re-sizes the volume marked by the @UBI_VTBL_AUTORESIZE_FLG in
+ * This function re-sizes the volume marked by the %UBI_VTBL_AUTORESIZE_FLG in
* the volume table to the largest possible size. See comments in ubi-header.h
* for more description of the flag. Returns zero in case of success and a
* negative error code in case of failure.