| Solomon Peachy | a910e4a | 2013-05-24 20:04:38 -0400 | [diff] [blame] | 1 | config CW1200 |
| 2 | tristate "CW1200 WLAN support" |
| 3 | depends on MAC80211 && CFG80211 |
| 4 | help |
| 5 | This is a driver for the ST-E CW1100 & CW1200 WLAN chipsets. |
| 6 | This option just enables the driver core, see below for |
| 7 | specific bus support. |
| 8 | |
| 9 | if CW1200 |
| 10 | |
| 11 | config CW1200_WLAN_SDIO |
| 12 | tristate "Support SDIO platforms" |
| 13 | depends on CW1200 && MMC |
| 14 | help |
| 15 | Enable support for the CW1200 connected via an SDIO bus. |
| Solomon Peachy | 7c0b6f4 | 2013-06-02 11:35:31 -0400 | [diff] [blame] | 16 | By default this driver only supports the Sagrad SG901-1091/1098 EVK |
| 17 | and similar designs that utilize a hardware reset circuit. To |
| 18 | support different CW1200 SDIO designs you will need to override |
| 19 | the default platform data by calling cw1200_sdio_set_platform_data() |
| 20 | in your board setup file. |
| Solomon Peachy | a910e4a | 2013-05-24 20:04:38 -0400 | [diff] [blame] | 21 | |
| 22 | config CW1200_WLAN_SPI |
| 23 | tristate "Support SPI platforms" |
| 24 | depends on CW1200 && SPI |
| 25 | help |
| Solomon Peachy | 7c0b6f4 | 2013-06-02 11:35:31 -0400 | [diff] [blame] | 26 | Enables support for the CW1200 connected via a SPI bus. You will |
| 27 | need to add appropriate platform data glue in your board setup |
| 28 | file. |
| Solomon Peachy | a910e4a | 2013-05-24 20:04:38 -0400 | [diff] [blame] | 29 | |
| Solomon Peachy | a910e4a | 2013-05-24 20:04:38 -0400 | [diff] [blame] | 30 | endif |