| Dongjin Kim | eab8050 | 2013-01-24 02:47:10 +0900 | [diff] [blame^] | 1 | SMSC USB3503 High-Speed Hub Controller |
| 2 | |
| 3 | Required properties: |
| 4 | - compatible: Should be "smsc,usb3503". |
| 5 | - reg: Specifies the i2c slave address, it should be 0x08. |
| 6 | - connect-gpios: Should specify GPIO for connect. |
| 7 | - intn-gpios: Should specify GPIO for interrupt. |
| 8 | - reset-gpios: Should specify GPIO for reset. |
| 9 | - initial-mode: Should specify initial mode. |
| 10 | (1 for HUB mode, 2 for STANDBY mode) |
| 11 | |
| 12 | Examples: |
| 13 | usb3503@08 { |
| 14 | compatible = "smsc,usb3503"; |
| 15 | reg = <0x08>; |
| 16 | connect-gpios = <&gpx3 0 1>; |
| 17 | intn-gpios = <&gpx3 4 1>; |
| 18 | reset-gpios = <&gpx3 5 1>; |
| 19 | initial-mode = <1>; |
| 20 | }; |