powerpc: Fix domain numbers in /proc on 64-bit
The code to properly expose domain numbers in /proc is somewhat
bogus on ppc64 as it depends on the "buid" field being non-0,
but that field is really pseries specific.
This removes that code and makes ppc64 use the same code as 32-bit
which effectively decides whether to expose domains based on
ppc_pci_flags set by the platform, and sets the default for 64-bit
to enable domains and enable compatibility for domain 0 (which
strips the domain number for domain 0 to help with X servers).
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/powerpc/kernel/pci-common.c b/arch/powerpc/kernel/pci-common.c
index f36936d..607b431 100644
--- a/arch/powerpc/kernel/pci-common.c
+++ b/arch/powerpc/kernel/pci-common.c
@@ -53,8 +53,9 @@
/* ISA Memory physical address */
resource_size_t isa_mem_base;
-/* Default PCI flags is 0 */
-unsigned int ppc_pci_flags;
+/* Default PCI flags is 0 on ppc32, modified at boot on ppc64 */
+unsigned int ppc_pci_flags = 0;
+
static struct dma_mapping_ops *pci_dma_ops;
@@ -853,15 +854,12 @@
int pci_proc_domain(struct pci_bus *bus)
{
struct pci_controller *hose = pci_bus_to_host(bus);
-#ifdef CONFIG_PPC64
- return hose->buid != 0;
-#else
+
if (!(ppc_pci_flags & PPC_PCI_ENABLE_PROC_DOMAINS))
return 0;
if (ppc_pci_flags & PPC_PCI_COMPAT_DOMAIN_0)
return hose->global_number != 0;
return 1;
-#endif
}
void pcibios_resource_to_bus(struct pci_dev *dev, struct pci_bus_region *region,