net: use netdev_mc_count and netdev_mc_empty when appropriate
This patch replaces dev->mc_count in all drivers (hopefully I didn't miss
anything). Used spatch and did small tweaks and conding style changes when
it was suitable.
Jirka
Signed-off-by: Jiri Pirko <jpirko@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tulip/dmfe.c b/drivers/net/tulip/dmfe.c
index 5fc61c1..534afbd 100644
--- a/drivers/net/tulip/dmfe.c
+++ b/drivers/net/tulip/dmfe.c
@@ -658,9 +658,9 @@
/* Send setup frame */
if (db->chip_id == PCI_DM9132_ID)
- dm9132_id_table(dev, dev->mc_count); /* DM9132 */
+ dm9132_id_table(dev, netdev_mc_count(dev)); /* DM9132 */
else
- send_filter_frame(dev, dev->mc_count); /* DM9102/DM9102A */
+ send_filter_frame(dev, netdev_mc_count(dev)); /* DM9102/DM9102A */
/* Init CR7, interrupt active bit */
db->cr7_data = CR7_DEFAULT;
@@ -1052,6 +1052,7 @@
{
struct dmfe_board_info *db = netdev_priv(dev);
unsigned long flags;
+ int mc_count = netdev_mc_count(dev);
DMFE_DBUG(0, "dmfe_set_filter_mode()", 0);
spin_lock_irqsave(&db->lock, flags);
@@ -1064,19 +1065,19 @@
return;
}
- if (dev->flags & IFF_ALLMULTI || dev->mc_count > DMFE_MAX_MULTICAST) {
- DMFE_DBUG(0, "Pass all multicast address", dev->mc_count);
+ if (dev->flags & IFF_ALLMULTI || mc_count > DMFE_MAX_MULTICAST) {
+ DMFE_DBUG(0, "Pass all multicast address", mc_count);
db->cr6_data &= ~(CR6_PM | CR6_PBF);
db->cr6_data |= CR6_PAM;
spin_unlock_irqrestore(&db->lock, flags);
return;
}
- DMFE_DBUG(0, "Set multicast address", dev->mc_count);
+ DMFE_DBUG(0, "Set multicast address", mc_count);
if (db->chip_id == PCI_DM9132_ID)
- dm9132_id_table(dev, dev->mc_count); /* DM9132 */
+ dm9132_id_table(dev, mc_count); /* DM9132 */
else
- send_filter_frame(dev, dev->mc_count); /* DM9102/DM9102A */
+ send_filter_frame(dev, mc_count); /* DM9102/DM9102A */
spin_unlock_irqrestore(&db->lock, flags);
}