bnx2x: Using the new FW
The new FW improves the packets per second rate. It required a lot of change in
the FW which implies many changes in the driver to support it. It is now also
possible for the driver to use a separate MSI-X vector for Rx and Tx - this also
add some to the complicity of this change.
All things said - after this patch, practically all performance matrixes show
improvement.
Though Vladislav Zolotarov is not signed on this patch, he did most of the job
and deserves credit for that.
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x_reg.h b/drivers/net/bnx2x_reg.h
index 8e9e7a2..25639e2 100644
--- a/drivers/net/bnx2x_reg.h
+++ b/drivers/net/bnx2x_reg.h
@@ -370,7 +370,6 @@
#define CFC_REG_NUM_LCIDS_LEAVING 0x104018
/* [RW 8] The event id for aggregated interrupt 0 */
#define CSDM_REG_AGG_INT_EVENT_0 0xc2038
-#define CSDM_REG_AGG_INT_EVENT_1 0xc203c
#define CSDM_REG_AGG_INT_EVENT_10 0xc2060
#define CSDM_REG_AGG_INT_EVENT_11 0xc2064
#define CSDM_REG_AGG_INT_EVENT_12 0xc2068
@@ -378,37 +377,27 @@
#define CSDM_REG_AGG_INT_EVENT_14 0xc2070
#define CSDM_REG_AGG_INT_EVENT_15 0xc2074
#define CSDM_REG_AGG_INT_EVENT_16 0xc2078
-#define CSDM_REG_AGG_INT_EVENT_17 0xc207c
-#define CSDM_REG_AGG_INT_EVENT_18 0xc2080
-#define CSDM_REG_AGG_INT_EVENT_19 0xc2084
#define CSDM_REG_AGG_INT_EVENT_2 0xc2040
-#define CSDM_REG_AGG_INT_EVENT_20 0xc2088
-#define CSDM_REG_AGG_INT_EVENT_21 0xc208c
-#define CSDM_REG_AGG_INT_EVENT_22 0xc2090
-#define CSDM_REG_AGG_INT_EVENT_23 0xc2094
-#define CSDM_REG_AGG_INT_EVENT_24 0xc2098
-#define CSDM_REG_AGG_INT_EVENT_25 0xc209c
-#define CSDM_REG_AGG_INT_EVENT_26 0xc20a0
-#define CSDM_REG_AGG_INT_EVENT_27 0xc20a4
-#define CSDM_REG_AGG_INT_EVENT_28 0xc20a8
-#define CSDM_REG_AGG_INT_EVENT_29 0xc20ac
#define CSDM_REG_AGG_INT_EVENT_3 0xc2044
-#define CSDM_REG_AGG_INT_EVENT_30 0xc20b0
-#define CSDM_REG_AGG_INT_EVENT_31 0xc20b4
#define CSDM_REG_AGG_INT_EVENT_4 0xc2048
-/* [RW 1] The T bit for aggregated interrupt 0 */
-#define CSDM_REG_AGG_INT_T_0 0xc20b8
-#define CSDM_REG_AGG_INT_T_1 0xc20bc
-#define CSDM_REG_AGG_INT_T_10 0xc20e0
-#define CSDM_REG_AGG_INT_T_11 0xc20e4
-#define CSDM_REG_AGG_INT_T_12 0xc20e8
-#define CSDM_REG_AGG_INT_T_13 0xc20ec
-#define CSDM_REG_AGG_INT_T_14 0xc20f0
-#define CSDM_REG_AGG_INT_T_15 0xc20f4
-#define CSDM_REG_AGG_INT_T_16 0xc20f8
-#define CSDM_REG_AGG_INT_T_17 0xc20fc
-#define CSDM_REG_AGG_INT_T_18 0xc2100
-#define CSDM_REG_AGG_INT_T_19 0xc2104
+#define CSDM_REG_AGG_INT_EVENT_5 0xc204c
+#define CSDM_REG_AGG_INT_EVENT_6 0xc2050
+#define CSDM_REG_AGG_INT_EVENT_7 0xc2054
+#define CSDM_REG_AGG_INT_EVENT_8 0xc2058
+#define CSDM_REG_AGG_INT_EVENT_9 0xc205c
+/* [RW 1] For each aggregated interrupt index whether the mode is normal (0)
+ or auto-mask-mode (1) */
+#define CSDM_REG_AGG_INT_MODE_10 0xc21e0
+#define CSDM_REG_AGG_INT_MODE_11 0xc21e4
+#define CSDM_REG_AGG_INT_MODE_12 0xc21e8
+#define CSDM_REG_AGG_INT_MODE_13 0xc21ec
+#define CSDM_REG_AGG_INT_MODE_14 0xc21f0
+#define CSDM_REG_AGG_INT_MODE_15 0xc21f4
+#define CSDM_REG_AGG_INT_MODE_16 0xc21f8
+#define CSDM_REG_AGG_INT_MODE_6 0xc21d0
+#define CSDM_REG_AGG_INT_MODE_7 0xc21d4
+#define CSDM_REG_AGG_INT_MODE_8 0xc21d8
+#define CSDM_REG_AGG_INT_MODE_9 0xc21dc
/* [RW 13] The start address in the internal RAM for the cfc_rsp lcid */
#define CSDM_REG_CFC_RSP_START_ADDR 0xc2008
/* [RW 16] The maximum value of the competion counter #0 */
@@ -1421,6 +1410,8 @@
/* [RW 1] e1hmf for WOL. If clr WOL signal o the PXP will be send on bit 0
only. */
#define MISC_REG_E1HMF_MODE 0xa5f8
+/* [RW 32] Debug only: spare RW register reset by core reset */
+#define MISC_REG_GENERIC_CR_0 0xa460
/* [RW 32] GPIO. [31-28] FLOAT port 0; [27-24] FLOAT port 0; When any of
these bits is written as a '1'; the corresponding SPIO bit will turn off
it's drivers and become an input. This is the reset state of all GPIO
@@ -1729,6 +1720,7 @@
/* [RW 3] for port0 enable for llfc ppp and pause. b0 - brb1 enable; b1-
tsdm enable; b2- usdm enable */
#define NIG_REG_LLFC_EGRESS_SRC_ENABLE_0 0x16070
+#define NIG_REG_LLFC_EGRESS_SRC_ENABLE_1 0x16074
/* [RW 1] SAFC enable for port0. This register may get 1 only when
~ppp_enable.ppp_enable = 0 and pause_enable.pause_enable =0 for the same
port */
@@ -2079,6 +2071,7 @@
#define PXP2_REG_PGL_ADDR_94_F0 0x120540
#define PXP2_REG_PGL_CONTROL0 0x120490
#define PXP2_REG_PGL_CONTROL1 0x120514
+#define PXP2_REG_PGL_DEBUG 0x120520
/* [RW 32] third dword data of expansion rom request. this register is
special. reading from it provides a vector outstanding read requests. if
a bit is zero it means that a read request on the corresponding tag did
@@ -2239,6 +2232,9 @@
allocated for vq22 */
#define PXP2_REG_RD_MAX_BLKS_VQ22 0x1203d0
/* [RW 8] The maximum number of blocks in Tetris Buffer that can be
+ allocated for vq25 */
+#define PXP2_REG_RD_MAX_BLKS_VQ25 0x1203dc
+/* [RW 8] The maximum number of blocks in Tetris Buffer that can be
allocated for vq6 */
#define PXP2_REG_RD_MAX_BLKS_VQ6 0x120390
/* [RW 8] The maximum number of blocks in Tetris Buffer that can be
@@ -3835,6 +3831,7 @@
#define TM_REG_LIN0_PHY_ADDR 0x164270
/* [RW 1] Linear0 physical address valid. */
#define TM_REG_LIN0_PHY_ADDR_VALID 0x164248
+#define TM_REG_LIN0_SCAN_ON 0x1640d0
/* [RW 24] Linear0 array scan timeout. */
#define TM_REG_LIN0_SCAN_TIME 0x16403c
/* [RW 32] Linear1 logic address. */
@@ -4363,6 +4360,7 @@
#define USDM_REG_AGG_INT_EVENT_31 0xc40b4
#define USDM_REG_AGG_INT_EVENT_4 0xc4048
#define USDM_REG_AGG_INT_EVENT_5 0xc404c
+#define USDM_REG_AGG_INT_EVENT_6 0xc4050
/* [RW 1] For each aggregated interrupt index whether the mode is normal (0)
or auto-mask-mode (1) */
#define USDM_REG_AGG_INT_MODE_0 0xc41b8
@@ -4379,6 +4377,10 @@
#define USDM_REG_AGG_INT_MODE_19 0xc4204
#define USDM_REG_AGG_INT_MODE_4 0xc41c8
#define USDM_REG_AGG_INT_MODE_5 0xc41cc
+#define USDM_REG_AGG_INT_MODE_6 0xc41d0
+/* [RW 1] The T bit for aggregated interrupt 5 */
+#define USDM_REG_AGG_INT_T_5 0xc40cc
+#define USDM_REG_AGG_INT_T_6 0xc40d0
/* [RW 13] The start address in the internal RAM for the cfc_rsp lcid */
#define USDM_REG_CFC_RSP_START_ADDR 0xc4008
/* [RW 16] The maximum value of the competion counter #0 */