[SCSI] add support for variable length extended commands
Add support for variable-length, extended, and vendor specific
CDBs to scsi-ml. It is now possible for initiators and ULD's
to issue these types of commands. LLDs need not change much.
All they need is to raise the .max_cmd_len to the longest command
they support (see iscsi patch).
- clean-up some code paths that did not expect commands to be
larger than 16, and change cmd_len members' type to short as
char is not enough.
Signed-off-by: Boaz Harrosh <bharrosh@panasas.com>
Signed-off-by: Benny Halevy <bhalevy@panasas.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/scsi.c b/drivers/scsi/scsi.c
index 749c9c7..110e776 100644
--- a/drivers/scsi/scsi.c
+++ b/drivers/scsi/scsi.c
@@ -79,15 +79,6 @@
#define MIN_RESET_PERIOD (15*HZ)
/*
- * Macro to determine the size of SCSI command. This macro takes vendor
- * unique commands into account. SCSI commands in groups 6 and 7 are
- * vendor unique and we will depend upon the command length being
- * supplied correctly in cmd_len.
- */
-#define CDB_SIZE(cmd) (((((cmd)->cmnd[0] >> 5) & 7) < 6) ? \
- COMMAND_SIZE((cmd)->cmnd[0]) : (cmd)->cmd_len)
-
-/*
* Note - the initial logging level can be set here to log events at boot time.
* After the system is up, you may enable logging via the /proc interface.
*/
@@ -709,9 +700,11 @@
* Before we queue this command, check if the command
* length exceeds what the host adapter can handle.
*/
- if (CDB_SIZE(cmd) > cmd->device->host->max_cmd_len) {
+ if (cmd->cmd_len > cmd->device->host->max_cmd_len) {
SCSI_LOG_MLQUEUE(3,
- printk("queuecommand : command too long.\n"));
+ printk("queuecommand : command too long. "
+ "cdb_size=%d host->max_cmd_len=%d\n",
+ cmd->cmd_len, cmd->device->host->max_cmd_len));
cmd->result = (DID_ABORT << 16);
scsi_done(cmd);